Dyson HU02-SN Airblade V Low Voltage Hand Dryer Sprayed Nickel

Dyson HU02-SN Airblade V Low Voltage Hand Dryer Sprayed Nickel

The Dyson HU02 (Formerly AB12) Airblade V hand dryer has a polycarbonate casing with a sprayed nickel molded plastic color finish.
Input voltage: Low Voltage = 110-127 Volts

The Dyson digital motor V4 is the only hand dryer motor powerful enough to draw in 28 liters of air a second through a HEPA filter, and then dry hands in 12 seconds. There are only three moving parts, so there are no slip rings or carbon brushes to wear down.

Because the Dyson Airblade V hand dryer uses the latest Dyson digital motor it is just 4 inches deep, so it complies with the Americans with Disabilities Act. It can be installed without additional recessing costs.

The Dyson Airblade V hand dryer uses two sheets of air that span the width of each hand to scrape off water like a windshield wiper and dries hands hygienically in 12 seconds.

The Dyson Airblade V hand dryer uses two HEPA filters to remove 99.97% of bacteria at 0.3 microns from the air used to dry hands. So hands are dried using cleaner air, not dirty air.

The Dyson Airblade V hand dryer has touch-free operation where capacitive sensors activate air to dry hands and a sealed casing infused with antimicrobial additives to protect the product.

Dimensions: 15 1/2" High x 9 1/4" Wide x 4" Deep