Bobrick B-715 115V Elan™ Surface Mounted Automatic Hand Dryer

Bobrick B-715 115V Elan™ Surface Mounted Automatic Hand Dryer

Bobrick Elan™ Series

Surface-mounted hand dryer shall have a deep-drawn, 20-gauge (0.9mm) thick, stainless steel cover with satin finish.
Mounting base and fan housing shall be fire-retardant molded plastic.
Capacitor run, external rotor motor shall be 90 watts, sealed with ball bearings on ends of drive shaft, and be equipped with a thermal overload switch.
Centrifugal fan shall have multiple metallic vanes.
Heating element shall be located on inlet side of fan, shall heat without hot spots, be inaccessible to vandals, and protected by an automatic thermal-overload switch and thermal fuse.
Electronic sensor shall automatically turn dryer on when hands are held under air-outlet opening and across path of sensor.
Dryer shall turn off automatically when hands are removed.
Sensor shall automatically shut dryer off approximately two minutes after dryer turns on if an inanimate object is placed across sensor lens.
After inanimate object is removed, electronic sensor shall automatically reset itself and dryer shall operate normally.
Unit shall be cULus Listed.
Unit shall comply with EU Directive “Restriction of Hazardous Substance” (ROHS) requirements for non-use of certain hazardous substances in the production of electronic products.

Voltage: 115V

Hand Dryer Measurement: 11 5/8" Wide x 11" High, Extends 5 9/16" from Wall